Plywood For Wind Mitigation For Windows And Doors

Drill holes 2 1 2 inches from the outside edge of the plywood at each corner and at 12 inch intervals.

Plywood for wind mitigation for windows and doors.

Taking the time to board up your home when a hurricane is approaching and evacuation is imminent is not always wise. If you do the work yourself. Pre install screw anchors around window openings to speed up installation. Use heavy duty screws and anchors in wood or expansion bolts in masonry to attach the plywood to your home s walls not the window frames.

However putting up plywood or storm shutters is time consuming and may require more than one person to lift heavy panels into place. Cut sheets of 1 2 or 5 8 inch thick plywood. To minimize damage to your home during a hurricane windows and doors should be boarded up with 5 8 plywood or covered with approved storm shutters. Cut the plywood to the measurements for each opening.

Drill four holes in the center area of the plywood to relieve pressure during a strong wind storm. Plywood shutters can be punctured by airborne objects but the florida building commission believes the puncture will be too small to do catastrophic damage in our anticipated wind speeds. Plywood that is not properly attached to your house can rip off during high winds and become a projectile that can cause serious harm to properties. Covering your windows and doors with plywood should only be used as a temporary emergency board up option not a permanent solution.

A contractor might charge between 3 5 sq. Make sure you overlap window frames by a good 8 inches all around.