Pocket Door Handle Installation

Place a mark where this lever comes into contact with door jamb.

Pocket door handle installation.

Jun 23 2020 explore hartford bldg prod s board pocket door hardware on pinterest. Mark the spots for the mounting screws using an awl. Be sure to screw the brackets into the studs. Next install the slider track using the rails that came in your pocket door kit.

You can install the door pull on any pocket door that s been previously installed. Step 4 drill holes. 1 pull the door halfway open by grasping the edge of it with your fingertips. See more ideas about pocket door hardware pocket doors door hardware.

How to install your pocket door hardware in 5 steps. Nail the end plate to the wall studs. Step 2 position pocket door pull. Check that the track is level so that the door rolls easily.

Install the header and track assembly on the top jamb with the fasteners and brackets supplied with the door. Enjoy the videos and music you love upload original content and share it all with friends family and the world on youtube. Then cut the exposed studs to make room for the new framing. To use the locking lever turn the lever which is on the lock body at the side.

Then put the hardware and door into the slider track. Follow the manufacturer s instructions and cut the pocket door header and track assembly to length with a hacksaw. Use your pencil to mark the jamb of the door for the latch plate to be installed. Trace the lever outline on the door s edge.

Step 3 mark the screw points. Step 1 read the directions. Measure up 36 inches from the floor. Wherever you purchased your pocket door hardware start by reading the directions that come with the door hardware that you purchased make sure that the hardware is for the thickness and the type of door that you are installing the hardware for and take note of any warnings or special notes the manufacturer gives.

To install a pocket door start by removing the existing door and the drywall on one side of the wall. Door knobs pulls lock sets other accessories hardware installation instructions and manuals resources from emtek products inc. Position the pocket door pull on the edge of the door backwards and mark the center using a carpenter s pencil.