Power Door Lock Not Working On 2008 Dodge Ram

I took the wire harness out and tested it and it works fine.

Power door lock not working on 2008 dodge ram.

The most recently reported issues are listed below. Usual cause the power door locks utilize individual solenoids in each of the doors that activate the door lock mechanism. Dodge ram 1500 owners have reported 2 problems related to power door locks not working under the electrical system category. It runs off a 5 volt reference.

21 people found this helpful. Symptom summary the power door locks are all inoperative or a single door lock is inoperative. I read in a forum that it could be the relay that has a 25a fuse in it that. Even if you change the acuators the locks still will not work until the code is cleared.

The 2008 dodge ram 1500 has 1 problems reported for power door lock stopped working. Could be the issue or the relay it self is bad. The switch provides power to the door lock solenoids. The reason the locks dont work more then likely there is a code stored in the bcm for a lock output circuit normally caused by one if not both of the sliding door acuators.

What a forked up way to build stuff. Windows can still work but locks will all stop. Average repair cost is 200 at 62 150 miles. Check the driver side door switch control if that goes bad all the locks will stop working including for the key fob.

Posted on sep 25 2008. My power windows on a 2008 dodge ram 1500 will not close. Diagnose power door locks don t work properly. All the switches on all four doors will not work either.

The most recently reported issues are listed below.