When your garage door won t open with the remote there are few things that can cause this problem.
Pulled safety now garage door wont open.
Now if your garage door stops opening up before it gets to 5 feet you ll need to adjust the open or up force nob.
If your garage door is stuck in the open position please contact precision door of spokane immediately so we can fix your door before serious damage occurs.
If you get it open then you will have to prop it up with something since it is now released and won t stay up on its own.
In the funniest of scenarios the problem will simply be due to an unplugged power cord.
Make sure it is hanging down from the motor.
If it is working properly your door should close or open without any problems.
If the door opens with the wall switch a simple battery change in the remote should do the trick.
If your garage door opens part of the way at least 5 feet and then stops you ll want to turn the up limit knob to the right.
Check the door s electric eye.
You might be out of range.
Pull the emergency release cord.
In order to fix this you ll want to make small changes to the close limit setting until the door opener knows to stop once the door has reached the floor.
Many garage doors have a powerful torsion spring located horizontally above the door.
When the door is lowered the spring winds up tightly creating a pulling force that helps lift the door up.
Do not attempt this if the door is wide open.
If it doesn t budge then try pulling on the red cord again.
The antenna on the motor could be damaged or blocked from the signal.
This is the emergency disconnect that will release the door.
Use a screwdriver to tighten the wire.
You may want to pull the cord the other way to see if that works.
It will come crashing down and could cause some damage.
Turn the power back on and the door should open and close normally.
Do not stand under the door.
Pull the cord to release it.
Sometimes a garage door won t open or close for one reason only the operator has no power connection.
If it is still not working recheck the connection at the top.
Do not pull so tight that you damage the cord or the lever.
You might have absentmindedly unplugged the operator as you were exiting the garage through your internal door to the house.
If your garage door is closing fully and then reversing to open again then it may be due to a problem with the close limit switch.
We have 24 7 emergency services just for situations as hazardous as this.