Roll Roofing Installation Step By Step

The line will serve as the guide where the first metal sheet will be installed.

Roll roofing installation step by step.

Apply roofing cement to the roof. Position the first course so it overhangs the drip edges by about 1 4 inch and roll it out a. Roll out and cut roll roofing to cover the length of the roof. Cut the shingles to fit around the flange s dome.

Installing the rolled roofing 1. Use a trowel to scoop up the roofing cement. 2 like any other roof project you should start this one by addressing the valleys. This aluminum flashing protects the edges of the roof sheathing.

Spread the roofing cement along the. 3 take a roll of 18 inch wide roofing and use it to cover the length of the valley. Cut the rolled roofing. Install a drip edge around the perimeter of the roof.

Prepare roof edges cant strips. 10 easy steps for diy rolled roofing installation 1 spend some time cleaning the roof before beginning a rolled roofing installation project. To seal a plumbing vent spread roofing. Attach it to the valley with roofing nails spaced 6 inches apart about 3 4 inch from the edge.

Step 1 draw the base line for you to have a basis on where to proceed with the installation of roof rolls create a line to serve as a mark. Install drip edge and install 9 cant strips of roll roofing material along the rake and eaves edges gable ends and lower roof edge such that the roofing strip overhangs the roof deck by 1 4 to 3 8. If the plumbing vent is close to the peak of the roof lap the shingles over the peak of the roof. How to do it attach first course.

This should give you a 1 inch overhang on the eaves including the top edge of. Adhere the shingles adjacent to the flange with roofing tar. Place the top edge of the roofing along the chalk line. Nail the roofing strips parallel to the roof edge set in 1 and 8 from the roof edge with nails spaced 4 o c.

Along the eave measure 35 1 2 inches and run the chalk line along this point. Using a measuring tape measure 35 inches 89 cm up from. Prepare a valley between joined roofs by cutting a strip that is 18 inches wide and covers the entire length of the. Adhere the joint where the cut edges of the shingles meet the dome with roofing tar.